Optimizer 16.2 instal the new version for iphone

The following output of the show ip pim interface detail command indicates that processing, forwarding, and origination of state refresh control messages is enabled. Use the show ip pim interface detail and the show ip pim neighbor commands to verify that the PIM Dense Mode State Refresh feature is configured correctly. The control message refreshes the prune state on the outgoing interfaces The PIM Dense Mode State Refresh feature keeps the pruned state in PIM dense mode from timing out by periodically forwardingĪ control message down the source-based distribution tree. This reflooding of unwanted traffic throughout the PIM dense mode

Is reflooded with multicast packets and prune messages.

However, the pruned state in PIM dense mode times out approximately every 3 minutes and the entire PIM dense mode network As a result, subsequent multicast packets are not flooded to pruned branches of the distribution PIM routers that receive multicast packets and have noĭirectly connected multicast group members or PIM neighbors send a prune message back up the source-based distribution tree Multicast packetsįrom a source are flooded to all areas of a PIM dense mode network. PIM dense mode builds source-based multicast distribution trees that operate on a flood and prune principle.

The PIM Dense Mode State Refresh feature is an extension of the PIM Version 2 multicast routing architecture.

Optimizer 16.2 instal the new version for iphone